NO | PARAMETER | UNIT | SPECIFICATION |
---|---|---|---|
1 | Laser Peak Wavelength | nm | 1310/1330/1510/1530/1550/1570/1590 |
2 | Spectral width | nm | <1nm(-20db) |
3 | Normal output power, Pf | mW | >3mW |
4 | Optical isolation of output isolator | dB | >30dB |
NO
|
Parameter
|
Unit
|
Specification
|
---|---|---|---|
1 | Operating voltage | V | <2V @ Pf=3mW |
2 | Operating current | mA | <100mA @ Pf=3mW |
3 | Threshold current | mA | <20mA |
4 | Slope efficiency | - | 0.05<η<0.25 W/A (Sumitomo Laser Diode) |
5 | Series Resistance | - | 4<RLD<8Ω |
6 | Bandwidth | GHz | >2.5GHz, -3dB |
7 | Relative Intensity Noise, RIN | dB/Hz |
-158dBm/Hz at 800MHz, -154dBm/Hz at 1.6GHz, -150dBm/Hz at 2.2GHz |
8 | 3rd Order Inter Modulation | dBc | Under -63dBc at 2.2GHz |
NO
|
Parameter
|
Unit
|
Specification
|
---|---|---|---|
1 | Monitor | mA | 0.1<η<1.2 mA @ Pf =3mW, VRPD =5V |
2 | Operating current | mA | <0.1uA |
3 | Threshold current | mA | ± 1dB, -25 to +85°C referenced to Pf =3mW @ +25°C |
1. Even though barely visible to the human eye, laser beam can be harmful to the eye. Do not look at the beam though lenses when the diode is activated 2. When adjusting the optical axis or making similar adjustments,we recommend that be sure to wear protective glasses 3. A glass-fiber is attached on the product, Handle with care
NO
|
Parameter
|
Unit
|
Specification
|
---|---|---|---|
1 | Wavelength | nm | 1100~1700 |
2 | Dark current | Na | < 1nA (@ Vr=5V) |
3 | Reverse Breakdown Voltage | V | 30V (@ lrd=100uA) |
4 | Capacitance | Pf | < 1pF (@ Vr=5V) |
5 | Frequency Response | MHz | 1~3000MHz (@ -3dB, Vr=5V) |
NO
|
Parameter
|
Unit
|
Specification
|
---|---|---|---|
1 | Responsivit | AW |
>0.85mA/mW @ 1310nm >0.9mA/mW @ 1550nm |
2 | Back Reflection | Db | < -45dB |
3 | Detection Range | nm | 1100nm to 1700nm ( @ Vr=5V) |
4 | Operating Temperature | ℃ | -25~75 |
1. Fiber length in assembly 2. Optical Fiber(Single mode) : According to ITU-T G.652.A or better (For example Corning SMF-28e) 3. Optical Connector : SC/APC 4. Customizing Design According to Customer Request
1. Even though barely visible to the human eye, laser beam can be harmful to the eye. Do not look at the beam though lenses when the diode is activated 2. When adjusting the optical axis or making similar adjustments,we recommend that be sure to wear protective glasses 3. A glass-fiber is attached on the product, Handle with care
NO
|
Parameter
|
Unit
|
Specification
|
||
---|---|---|---|---|---|
1 | Frequency | MHz | TX 29.9 / RX 26.9 MHz | ||
TX 26.9 / RX 29.9MHz | |||||
2 | Receiver | Sensitivity | dBm | -10~ -75dBm |
-71dBm setting Refer to (1) |
Frequency Deviation | KHz | 40KHz / ±15 KHz | |||
3 | Spurious | 2nd Harmony | dBc | -60dBc min. | - |
3rd Harmony | -70 dBc min | ||||
4 | Transmitter | Output Power | dBm | -10 ±2dBm | Customized |
Frequency Shift | KHz | H:fo+20 / L:fo-60 KHz |
Data 1 = H Data 0 = L |
||
Deviation | '±5kHz | ||||
5 | Power | Input power | V | 5±0.2 V / 30mA | - |
6 | Data rate | bps | 19200 bps | Refer to (2) | |
7 | Impedance | Ω | 50 +/-(j)20 | ||
8 | Operating Temperature Range | ℃ | -30 ~ +80 | ||
9 | Storage Temperature Range | ℃ | -35 ~ +90 | ||
NOTE |
Test conditions: After termination, the above data are measured. (1) Sensitivity will be -73±3 dBm if there's no special request. (2) Data Rate will be 19200bps if there's no special request. |
Port
|
Insertion Loss
|
Isolation
|
---|---|---|
1310 | 1.3 | >30 |
1330 | 1.2 | >15 |
15xx | 0.7 | >17 |
Port
|
Insertion Loss
|
Isolation
|
---|---|---|
1310 | 0.7 | >17 |
15xx | 0.7 | >17 |
OCW82 | PORT | Insertion Loss |
---|---|---|
20%PORT | 7.9 | |
80%PORT | 1.2 | |
OCW73 | PORT | Insertion Loss |
30%PORT | 6.0 | |
70%PORT | 1.9 | |
OCW64 | PORT | Insertion Loss |
40%PORT | 4.7 | |
60%PORT | 2.7 | |
OCW55 | PORT | Insertion Loss |
50%PORT | 3.6 | |
50%PORT | 3.6 |